The PTS-Passive Probe Adapter-440 adapter lets you keep two passive devices like the Tormach Passive Probe (32309/32310) connected at the same time to a Tormach PCNC 440 mill.

Aluminum enclosure.

Will save your probe if you forget to switch the plug.

No need to go to settings page when switching between Passive Probe or other Passive devices.

Just plug the adapter into the mill and any USB port on the controller or USB power block.

>5 1/2 foot long cords to allow placement in front of mill.

LED can be used for very fast XYZ Zero operations.

No change of dimensions. Switch time is less than 3ms thru adapter.

Super Bright LED indicator will light when either the probe or PTS is tripped.

Both plugs must have a passive device or shorting plug installed at all times.

Installation Manual


Supported Models
PCNC 440® Powered from Power Supply (Wall Wart) or any controller USB port.

Write a review

Note: HTML is not translated!
    Bad           Good

PTS-Passive Probe Adapter-440

  • $99.95

Related Products

Probe Bypass Plug

Probe Bypass Plug

The MillFast Probe Bypass Plug us used when you are using a PTS or Passive Probe and want to remove the probe o..


Dual USB Power source

Dual USB Power source

2.1 Amp Max Wall USB power sourceInput Voltage 110-240 VoltsUSB Output Voltage: 5V +/- 0.5VOperating Temperature: 32┬░ - ..