The USB Joystick Controller lets you move your mill in the X, Y, and Z directions without having to use the keyboard or mouse. Especially convenient for manual milling of one-off parts.


Full Aluminum Enclosure.
Water resistant Joystick and pushbuttons.
USB controller is embedded in urethane to be 100% Waterproof and shockproof.
USB Controller plugs into any USB port on your controller (same as adding a second keyboard)
Four (4) high strength Neodymium magnets in base of controller to hold onto table or coolant tray.
No need to touch keyboard or mouse to move the table and spindle.
Compatible with Tormach® PathPilot® and Mach 3 control software.
Can be used in step or continuous movement mode.


Installation Manual
Limiter Plate

Supported Models
PCNC 1100® Yes
PCNC 770® Yes
PCNC 440® Yes
15L Slant-Pro® Yes

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha

USB Joystick

  • $129.95


Related Products

USB Extension 6 foot

USB Extension 6 foot

6 foot USB 2.0 High Speed extension with USB A male and USB A female connectors.Perfect for moving a USB port to a more ..

$9.95

USB Extension 3 foot

USB Extension 3 foot

3 foot USB 2.0 High Speed extension with USB A male and USB A female connectors.Perfect for moving a USB port to a ..

$8.95

USB 4 Port Hub

USB 4 Port Hub

USB 2.0 High Speed 4 port hub with USB A male connector.Compatible with PathPilot and Mach 3USB hub with 4-por..

$8.95

Magnetic USB Hub

Magnetic USB Hub

Magnetic Base USB 2.0 High Speed 4 port hub with USB A male connector.Compatible with PathPilot® and Mach 3USB..

$14.95