Our DIN5 Extension cable gives you the ability to easily route any wires from your 5 pin DIN to any device you want to connect.


This extension is especially handy for routing the RapidTurn® Sensor cable up and over the spindle when in use.


Extension cable is ~8 foot in length with one female and one male 5 pin DIN connector.


All 5 pins are connected on each end and there is no crossover like some cables.


Cable has been tested for compatibility with Tormach® devices.


Only Beige color available at this time.

Supported Models
PCNC 1100® Yes
PCNC 770® Yes
PCNC 440® Yes

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha

DIN 5 Extension

  • $11.95