RapidTurn® Shield Savers                         

A Shield Saver is a set of adapters that mount between the RapidTurn® and the plastic chip shield.

One half of the adapters screws into the existing holes and your original shield mounting screws connect to the other half.

They connect to each other with two very strong Neodymium magnets.

As an added benefit your shield will be offset from its original mounting by about 1 1/4 inch.

Only sold as a 5 piece set.  2 that mount to RapidTurn® and 2 that mount to the shield and 1 stand.

Installation Instructions

Supported Models
PCNC 1100® Yes
PCNC 770® Yes
PCNC 440® No

Write a review

Note: HTML is not translated!
    Bad           Good

Shield Savers

  • $29.68